Westermo MDI-112-F4G - Manual (Page 101)

97
4.7.3 CoS-Queue Mapping
This page is to change CoS values to Physical Queue mapping table. Since the
switch fabric supports four physical queues, Lowest, Low, Middle and High. Users
should therefore assign how to map CoS value to the level of the physical queue.
Users can freely assign the mapping table or follow the suggestion of the 802.1p
standard and Westermo uses 802.p suggestion as default values. You can find
CoS values 1 and 2 are mapped to physical Queue 0, the lowest queue. CoS
values 0 and 3 are mapped to physical Queue 1, the low/normal physical queue.
CoS values 4 and 5 are mapped to physical Queue 2, the middle physical queue.
CoS values 6 and 7 are mapped to physical Queue 3, the high physical queue.
After configuration, press Apply to enable the settings.
4.7.4 DSCP-Queue Mapping
This page is to change DSCP values to Physical Queue mapping table. Since the
switch fabric supports four physical queues, Lowest, Low, Middle and High. Users
should therefore assign how to map DSCP value to the level of the physical queue.
Users can freely change the mapping table to follow the upper layer 3 switch or
routers’ DSCP setting.