Westermo MDI-112-F4G - Manual (Page 44)

40
There are 2 modes for users to backup/restore the configuration file, Local File
mode and TFTP Server mode.
Local File mode: In this mode, the switch acts as the file server. Users can browse
the target folder and then type the file name to backup the configuration. Users
also can browse the target folder and select the existed configuration file to
restore the configuration back to the switch. This mode is only provided by Web
UI while CLI is not supported.
TFTP Server mode: In this mode, the switch acts as the TFTP client. Before you do
so, make sure that your TFTP server is ready. And then please type the IP address
of TFTP Server IP address. This mode can be used in both CLI and Web UI.
TFTP Server IP Address: You need to key in the IP address of your TFTP Server
here.
Firmware File Name: The file name of the new firmware.
The UI also shows you the current firmware version and built date of current
firmware. Please check the version number after the switch is rebooted.
Click on Upgrade to start the process.
After finishing transmitting the firmware, the system will copy the firmware file
and replace the firmware in the flash. The CLI show “……” until the process is
finished.
4.2.9 Factory Default
In this section, you can reset all the configurations of the switch to default setting.
Click on Reset the system will then reset all configurations to default setting. The
system will show you popup message window after finishing this command.
Default setting will work after rebooting the switch.
Popup alert screen to confirm the command. Click on Yes to start it.