Westermo MDI-112-F4G - Manual (Page 30)

26
4.2 Basic Setting
The Basic Setting group provides you to configure switch information, IP address
and user name/password of the system. It also allows you to do firmware
upgrade, backup and restore configuration, reload factory default, and reboot the
system.
Following commands are included in this section:
4.2.1 Switch Setting
4.2.2 Admin Password
4.2.3 IP Configuration
4.2.4 Time Setting
4.2.5 Jumbo Frame
4.2.6 DHCP Server
4.2.7 Backup and Restore
4.2.8 Firmware Upgrade
4.2.9 Factory Default
4.2.10 System Reboot
4.2.11 CLI Commands for Basic Setting
4.2.1 Switch Setting
You can assign System name, Location, Contact and view system information.
Figure 4.2.1.1 – Web UI of the Switch Setting
System Name: You can assign a name to the switch. The number of characters
you can input is 64. After you configure the name, CLI system will select the first
12 characters as the name in CLI system.
System Location: You can specify the switch’s physical location here. The number
of characters you can input are 64.