Westermo MDI-112-F4G - Manual (Page 14)

10
2.9 DIN-Rail Mounting Installation
The DIN-Rail clip is already attached to the Switch when packaged. If the DIN-Rail
clip is not screwed on the Switch, follow the instructions and the figure below to
attach the DIN-Rail clip to the switch.
Follow the steps below to mount to the switch on a DIN-Rail track:
1. First, insert the upper end of DIN-Rail clip into the back of the DIN-Rail track
from its upper side.
1. Use the screws to attach DIN-Rail clip to the real panel
2. To remove DIN-Rail clip, reverse step 1.