Welltech ePBX-100A-128 User Manual
Page 43
43
to 0 to ignore the digits length.
Primary/Secondary/Third: User can set three priorities for each routing rule, if
ePBX-100A-128 fails to route to primary destination three times, it will try to route to
secondary or third destination.
Destination: Here you can find some destination (Trunk) for choosing. You can define
the destination for the prefix route.
Note:
•
Before setting the Routing Table, you should set the Trunk info in the Trunk
page first. So that this field will contain the Trunk ID for choosing.
• If the Trunk was setting to Dynamic in the Host field, but it doesn’t register on
ePBX-100A-128, ePBX-100A-128 will skip this “priority” and route call to next
priority immediately without trying. If the Trunk was setting to Address in the Host
field, but the Address is not reachable, ePBX-100A-128 will try three times then
route call to next priority.
Add: To add assigned number. For example, you set 02 here and the called number is
03123, the ePBX-100A-128 will add 02 then send 0203123 as the called number.
Drop: To drop specified length of number. For example, you set 2 here and the
called number is 03123, the ePBX-100A-128 will drop 03 then send 123 as outgoing
number.
Note:
•
If you set both of the Drop and Add, ePBX-100A-128 will Drop first then Add.
Example:
If user set prefix as
002
, digits length as 12, Primary destination as 888, Drop as
3
, and Add
as
0
.
When caller called
002
912345678, the prefix is
002
; length is 12, so this call matches the
routing rule.
002
912345678→912345678(Drop
3
digits) →0912345678(Add
0
)
Finally, ePBX-100A-128 will send 0912345678 to Trunk ID 888.
Route Password: Set password here so the ePBX-100A-128 will request password
before sending the call to Trunk.
Guest Allow: Enable Guest Allow will allow user who is not your subscriber (Extension)
to use such routing record. User can reach the Auto attendant (The default Auto
Attendant of ePBX-100A-128 is **999) first then send call to Destination (Trunk), if you
enable Guest Allow. If you disable Guest Allow, only the Extension can use this
Routing record.
Note: