Welltech ePBX-100A-128 - Manual (Page 30)

30
„ Voice Mail Box Login: For ePBX-100A only. ePBX-100A has the ability to store voice
mail within itself, and user can just dial to the feature code to login the voice mail
system. The feature code of voice mail system default is *98.
„ Camp-On Activated: This function means [call back on busy]. For example, you dial to
101 but 101 is on the phone, then you should hear an announcement for called person
is busy. You could dial to *66 by default to trigger the ePBX-100A-128 call back to you
when 101 is idle. This function will let u talk to called party immediately when called
party is not busy.
Note:
•
This Function is only workable when voice mail function is disabled.
• When this function is enabled, ePBX-100A-128 will check the status of called
party every 20 seconds, at most 15 times. That means the camp-on function may
be performed when called party is idled after 20 seconds at most. And 300 (20*15)
seconds later, this function will not be workable.
„ CLIR(per call) Prefix:
Default is *67. Add this prefix will hide the caller’s number. For
example, 101 does not hope to show the caller id to 102. 101 can just dial to "*67102",
where the *67 is the prefix for CLIR. When 102 got the incoming call, the LCD of 102
should display "Anonymous". If 101 just dial to "102", then 102 should see the Caller ID
as 101.
„ CLIR Activated:
Default is *31. For example. 101 dial to "*31", ePBX-100A-128 should
add the CLIR record for 101 into its database. When 101 call to 102, 103...,etc. The
LCD of called party should always show "Anonymous".
„ CLIR Deactivated: Default is *32. Dialing to *32 will remove the CLIR record from the
database of ePBX-100A-128.
„ ExtPwd Activated: User could enable personal password for outbound call by enable
ExtPwd. Default is *80. For example, 101 dial to *80+123, when the phone 101 dial an
outbound call number, ePBX-100A-128 will request a password.
„ ExtPwd Deactivated: User could disable personal password by *81 as default.
3.1.3 Extension
User has to set Extension account for other device to register on ePBX-100A-128.
Enter Configuration
Æ Extension to configure Extension data. User can press
Modify to add new Extension or modify configured Extension data. Press Delete will delete
the specified Extension.