Welltech IP-380 v.1.0 - Manual (Page 94)

iP380 User Manual
Welltech Technology Co., Ltd.
94 / 104 2012/11/01
(Figure 3)
Step 2: In [Management - Advanced Setting] web page, Set up [DHCP Gateway ARP Check Period:
30] (See Figure 4).
(Figure 4)
Example 3: Remote RFC2833 DTMF control Relay to Open/Close
Description 1. iP380 can be installed at entrance of office for visitor visiting. When the operator
staff confirm the identity of the visiting guests, operator staff press number key from
his/her own extension (Number DTMF: 0 ). Then iP380 activate software control
Relay to open the doors.
Note : This function support DTMF format mode: RFC2833 only, do not support InBand .
Description 2. Relay default parameter can configure to Normal Open (Relay’s contact is Open in
standby state) or Normal Close (Relay’s contact is Close in standby state ) state.
When configure to Normal Open, iP380 Relay’s contacts are open. Once iP380 was
activated, software control it to Close state. The state last for 3 seconds, then return
to Normal Open.
Description 3. When configure to Normal Close, iP380 Relay contacts are in close state. Once
iP380 was activated, software controls it to open state. The state keeps 3 seconds,
then return to Normal Close.
Description 4. iP380 can be installed at Network Control Center (NOC). Remote DTMF can control
Relay to be Open or Close to Reset Network equipment by remote IP Phone device
through DTMF signal. It also can be installed at house to control home automation
device via remote IP Phone through remote DTMF signal.
2.5.6. Password (Change Login Account)
2.5.6.1. Functions
Password Provides 3 Authority functions to change their User name and Password,
respectively.
2.5.6.2. Instruction
Figure 1: Admin