[sysconf] command – Welltech LP-201 Mar-11-2005 User Manual
Page 50

SIP SIP-Phone Administration Guide
49
12. [sysconf] command
1. -print: display all current configurations.
2. -idtime: set the duration (in second) of two pressed digits in dial mode as timed out.
If after the duration user hasn’t pressed next number, SIP-Phone will dial out all
number pressed.
3. –service: set SIP Phone to work as normal mode or hotline mode. If user wants to
use hotline function, please set service to be 1, and set bureau related configuration.
Please refer to 19. [bureau] command.
4. -keypad: set DTMF type. User can select DTMF type SIP-Phone receive and
transmit. (sysconf –keypad 0/1, 0 for in band, 1 for RFC2833, 2 for SIP-Info.)
5. -2833type: change RFC2833 Payload type.
6. -eod: select end of dialing key, e.g. set end of dial key as “*” button, after finished
pressing dialing number then press “*” will dial out. (sysconf –eod 0/1/2 , 0 for no
end of dial key , 1 for “*” button, 2 for “#” button )
7. –service: set SIP Phone to be normal mode or under hotline mode.
(sysconf –service 0/1, 0 for normal service, 1 for hotline service.)
Note:
To set SIP-Phone as hotline mode, user has to set SIP-Phone as Peer-to-Peer
mode, and hotline table under bureau command.