Welltech LP-201 Mar-11-2005 - Manual (Page 45)

SIP SIP-Phone Administration Guide
44
2. [quit] command
Type quit/exit/close will logout SIP-Phone and Telnet Program.
3. [debug] command
This command is for engineers to debug system of SIP-Phone. User can add debug
flag via command debug –add “debug flags”, and then start debug function via
command debug –open. When SIP-Phone is working on screen will display related
debug messages. Most frequently used debug flag are “sip”, “fsm”, “msg”…etc.
4. [reboot] command
After typing commit command, type reboot to restart the SIP-Phone.
Sometimes after user type reboot, on terminal screen will display: "Data modified,
commit to flash rom?” which means SIP-Phone will record call history or not. (Ex.
REDIAL, outgoing and incoming call data)
5. [pbook] command
This command is functional both in Proxy mode and Peer-to-Peer mode. In proxy mode,
use speed dial or 10 DL button will dial out e.164 number in phone book. In the other
hand, in peer-to-peer mode, SIP-Phone will dial out IP address.
1. -print: display phone book data. User can print all data in phone book by command
(pbook –print). Furthermore, user can also print only a section of data by indicate
parameter “start index” and “end index” (pbook –print “start index” “end index”).
If parameter “end index” is omitted, only record “start index” will be displayed.
(pbook –print “start prefix”).
2. -add: add a new record in phone book table by giving name, IP address, and e.164
number of callee endpoint.