Welltech LP-201 Mar-11-2005 - Manual (Page 30)

SIP SIP-Phone Administration Guide
29
2. SIP Information
Please refer to chapter 4.13 [SIP] command
- Run Mode: Select SIP-Phone to work under Peer-to-Peer mode or Proxy mode.
- Primary Proxy IP Address: Set Primary Proxy IP Address or URL address (Domain
Name Server must be configured. Please refer to Network Interface).
- Proxy port: Set Proxy port for SIP-Phone to send message, default value is 5060, if
there is no special request of Proxy server, please don’t change this value.
- Secondary Proxy IP Address: Set secondary proxy IP Address or URL address
(Domain Name Server must be configured. Please refer to Network Interface).
When LP201 fail to register to primary proxy. It will try to register to secondary Proxy,
when it fail again, it will retry to register to primary Proxy.
- Secondary Proxy port: Set the secondary proxy port for every SIP massage, default