Welltech LP-201 Mar-11-2005 - Manual (Page 15)

SIP SIP-Phone Administration Guide
14
Chapter 2 Configuring the SIP-Phone through LCD Phone
menus
Note:
1. After any configuration is made for the SIP-Phone, user has to do Reboot in the
selection 7 “Reboot”.
2. We suggest user to set IP address via LCD menu 5→ → → →2.3.4.5 first, then go to
chapter 3 to do other detail configurations via web browser.
1. Initialize SIP-Phone
1. When power on the SIP-Phone, the LCD screen shows as below. Now SIP-Phone is
running Boot sector program.
2. When SIP-Phone finishes boot program initialization. User can see flashing greeting
as below:
3. Then SIP-Phone get into standby mode:
The main LCD screen would be shown as similar as above. “ Proxy ” means the
SIP-Phone is in Proxy Mode, and when SIP-Phone is connected to SNTP server, on
LCD will show current time captured from SNTP server.
4. When SIP-Phone is under peer-to-peer mode, on LCD will show “ P2P ” instead of
“ Proxy ”.
5. After pressing the PSTN button, the “ Proxy ” or “ P2P ” will be replaced by “PSTN”.
IP-Phone
Board Start Booting
System Initializing…………..
SIP-Phone
Proxy 10:10:10 AM
SIP-Phone
P2P 10:10:10 AM