Welltech LP-201 Mar-11-2005 - Manual (Page 19)

SIP SIP-Phone Administration Guide
18
User can press or to check current network status:
(1) Mode: Display current network connection mode of SIP-Phone to be
Static (Fixed IP), DHCP, or PPPoE.
Note:
When SIP-Phone is under DHCP mode, then change to Static mode,
the following items: IP address, Subnet Mask, Default Gateway, will
display empty, after reboot, user can see information again.
(2) IP, Mask, Gateway: display current IP information.
2. Network Mode
Set network mode of SIP-Phone to be Static (Fixed IP), DHCP, or PPPoE.
3. IP address
Set IP address of SIP-Phone.
4. Subnet Mask:
Set subnet mask address of SIP-Phone.
5. Default Gateway
Set default gateway address of SIP-Phone.
6. Domain Name Server
Set IP address of Domain Name Server. Once SIP-Phone can connect to
DNS server, user can set URL address for Proxy server or Phone book
instead of IP address.
7. PPPoE Configuration
(1) User Name
Set PPPoE connection authentication user name.
(2) Password
Set PPPoE connection authentication password.
(3) Auto Re-connect
Choose ON or OFF to enable or disable this function. If user enables this
function, after PPPoE disconnected, SIP-Phone will automatically reboot
to re-connect, and after reboot, if SIP-Phone still can’t connect with server,
SIP-Phone will keep trying to connect. On the other hand, if user disables
this function, SIP-Phone won’t reboot and keep trying to connect.
8. SNTP Configuration
(1) SNTP Mode:
User can set SNTP function to be on or off, which means SIP-Phone will