Wavetronix Command DataView (CMD-DV) - User Guide - Manual (Page 62)

CHAPTER 6 • REPORTS PAGE 61
The Create as a scheduled report box should be checked if this is to be a regular report,
run consistently on a given interval. Uncheck this box if this is to be a singular report that
is run manually just once.
Options Tab
The Options tab contains any additional properties that are needed for the selected report
template.
Many reports do not require additional properties and pushing the Next button on the
Report Type tab will skip the Options tab in those cases. For report templates that require
additional properties, see the appendix for more information on valid values for any given
template properties visible on the Options tab.
Data Source Tab
The Data Source tab (see Figure 6.5) allows you to select the data source for the report.
Figure 6.5 – Data Source Tab
Reports can be drawn from any available data source, including the raw, imported data,
workbook data, or published data; however, reports can only be created from one single
data source. For reports from imported data, choose the Imported Data radio button and
select a data aggregation (5 minute, 15 minute, Hour). For reports from workbook or pub-
lished data, select the appropriate option and select the specific data source from the drop-
down list.
As before, it is the user’s responsibility to ensure that the chosen data source contains an
appropriate amount and type of data for the selected report.
Time Tab
The Time tab (Figure 6.6) allows users to select the date range for data within the chosen
data source that will be used within the report. By default, the start date and end date values
will be set to the beginning and ending time ranges for the chosen data source, although
users can always choose to adjust the time ranges to only use a subset of the data in the data
source for the report.