Wavetronix Command DataView (CMD-DV) - User Guide - Manual (Page 44)

CHAPTER 4 • DATA PAGE 43
Removing AADT/MADT Records
Yearly records for a station can be removed through either the View By Station or View By
Year lists. To remove a record, click the Delete link at the far right of the record.
Note
This operation cannot be undone.
Calculating AADT/MADT Records
DataView can automatically calculate AADT/MADT values for a given station if enough
data exists. To create new AADT/MADT records for a given year, open the Calculate Sta-
tion Values menu.
Figure 4.11 – Calculate Station Values Menu
Complete the following information:
˽ Use Published Data – Shows the published data source to use for the station data.
˽ Years – Displays possible years. Put checks next to the year(s) for which the calculation
should be done.
˽ Factor Groups – Provides options for factor group assignments when calculating
AADT/MADT statistics. If factor groups are enabled, each station with an incomplete
amount of data for the given year will attempt to extrapolate the missing data from
other stations in the same factor group in order to calculate the average monthly and
annual counts. There are four options:
Select Ignore to ignore factor group assignments for all stations.
Select Use For All Selected to use parallel data from another station to complete the
calculation.
Select Use For Selected Temporary Count Stations Only to use only designated sta-
tions to extrapolate incomplete data. Stations with incomplete data but without the
temporary counts station designation will use only their own data.
Select Use for All Selected with Minimum Threshold of Data to use data only from
stations that have the given minimum data threshold or less in hours and a comple-
mentary station in the same factor group with the Minimum Source Threshold or less.