Wavetronix Command DataView (CMD-DV) - User Guide - Manual (Page 36)

CHAPTER 4 • DATA PAGE 35
time.
4 Select an aggregation level—either 5-, 15- or 60-minute bins. In cases where the data in
Collector is in a smaller interval size than the selected aggregation level, DataView will
automatically aggregate the data to the desired bin size.
5 Click Import All to import data for all stations, or Import Selected to import data for
the selected stations only.
Note
Stations will need to be assigned one or more sensors on a Collector machine in order
to import data correctly. Stations without a sensor/lane assignment will not import
data, even if selected. For more information on mapping stations to Collector sensors
and lanes, see the Collector Settings section later in this chapter.
Once the import operation has begun, you do not need to remain on the Collector page.
Check the Notify me via email when complete checkbox before starting the import opera-
tion to receive an email when the import is complete. Use of this features requires a valid
email address and email server to be registered with DataView in the System > Settings
section.
Auto Tab
For convenience, import from Command Collector services can be done automatically on
the Auto tab. To activate auto-import, check the Enable Auto Data Import From Collec-
tor checkbox (see Figure 4.3)