WattMaster WCC III part 4 - Manual (Page 85)

WCC III Technical Guide 3-81
WCC3.EXE SCREEN DESCRIPTIONS
Binary Output Satellite # __2 Sat. #2 Time Date
08:49 1/23
Binary Outputs
RUN TIME TOTAL ON LAST
COMMENTS STATUS MODE TIME DELAY RUN TIME COUNT ON TIME
Bo1: S1-BO1 OFF 2:55 0 00 00 0 00/00 00:00
Bo2: S1-BO2 OFF 2:55 0 00 00 0 00/00 00:00
Bo3: S1-BO3 OFF 2:55 0 00 00 0 00/00 00:00
Bo4: S1-BO4 OFF 2:55 0 00 00 0 00/00 00:00
Bo5: S1-BO5 OFF 2:55 0 00 00 0 00/00 00:00
Bo6: S1-BO6 OFF 2:55 0 00 00 0 00/00 00:00
Bo7: S1-BO7 OFF 2:55 0 00 00 0 00/00 00:00
Bo8: S1-BO8 OFF 2:55 0 00 00 0 00/00 00:00
Bo9: S1-BO9 OFF 2:55 0 00 00 0 00/00 00:00
Bo10: S1-B10 OFF 2:55 0 00 00 0 00/00 00:00
Bo11: S1-B11 OFF 2:55 0 00 00 0 00/00 00:00
Bo12: S1-B12 OFF 2:55 0 00 00 0 00/00 00:00
Bo13: S1-B13 OFF 2:55 0 00 00 0 00/00 00:00
Bo14: S1-B14 OFF 2:55 0 00 00 0 00/00 00:00
Bo15: S1-B15 OFF 2:55 0 00 00 0 00/00 00:00
Bo16: S1-B16 OFF 2:55 0 00 00 0 00/00 00:00
HOME for menu
BINARY OUTPUT SUMMARY SCREEN
Binary Output
Specifi es the summary type to be displayed. Because this is a
“choice” fi eld, a list of available choices will be displayed at the
bottom of the screen:
Tren Logging, Logic Switch, Binary Output>
Make your selection by pressing the once for each
choice until the desired point type has been selected, and then
press
. (If you select a point type that is different than
that currently being displayed, the screen will be rewritten with the
appropriate screen and data.)
Satellite # _____
Specifi es the number of the satellite you are currently editing.
If you would like to edit a different satellite, simply position the
cursor to this fi eld by using the cursor positioning (arrow) keys,
enter the desired satellite number, and press
.
Time / Date
The present time and date will automatically appear at these
locations.
Comments
The description message which is entered on the Binary Output
Screen will automatically appear here to help you identify the
different binary outputs within the system.
Status
The present “ON” or “OFF” status of the binary output is shown
here. For example, if week schedule #1 (W1) has been input to
control the schedule, the message “ON” will appear here when
week schedule #1 is “ON” and “OFF” will appear when week
schedule #1 is “OFF”.
Binary Output Screen’s WCC III Logical Address is XXXOYY, where XXX = Satellite Address #,
O = Binary Output, YY = Binary Output #
Binary Output Summary Screen