WattMaster WCC III part 4 - Manual (Page 131)

WCC III Technical Guide 3-127
WCC3.EXE SCREEN DESCRIPTIONS
Analog Global #:____
Specifi es the global number and its type. Because this is a “choice”
fi eld, the list of available choices will be displayed at the bottom
of the screen:
Make your selection by pressing the once for each
choice until the desired global type has been selected, and then
press
. (If you select a global type that is different than
that currently being displayed, the screen will be rewritten with the
appropriate screen information.)
If you would like to edit a different global, simply position the
cursor to this fi eld by using the cursor positioning (arrow) keys,
entering the desired global number, and pressing
.
name is ______
Specifi es the name (point address) of this analog global. Any
changes to the global number will be refl ected in this point address
(e.g., ANALOG GLOBAL #: 28 would show GA 28 as the
name).
Description: ________________
Specifi es a short message which is displayed on Summary and Data
Entry/Editing Screens to aid you in remembering points within the
system. You may enter up to 20 characters (control, codes, ALT
codes, and the double quote character are not allowed).
ANALOG GLOBAL SCREEN
ANALOG Global #: 20 name is GA 20
Description: Example Data Pattern: xxx.x
Unit of Measure: 2
In Local Set this global defaults to LAST value.
Mode 4: Math Function
Global Value = 1a2
If this function cannot be calculated successfully, then use 65.0
-------------------------------------ALARM----------------------------------
Range
Low Limit High Limit Type Message # Message
None ---- ---- 0 0
Data Pattern: _____
Specifi es the number of signifi cant digits for analog global values
displayed by the system. Because this is a “choice” fi eld, the list of
available choices will be displayed at the bottom of the screen:
Units of Measure:
Specifi es a message number to be used throughout the system to
reference a textual message which is displayed with the values
associated with this global. For example, if units of measure
message #4 is Deg F, and the units of measure message for the
specifi c analog global is degrees Fahrenheit, then the units of
measure would be 4.
In Local Set this global defaults to
Because this is a “choice” fi eld, the list of available choices will be
displayed at the bottom of the screen:
Make your selection by pressing the once for each
choice until the desired default choice has been selected, and then
press
.
Analog Global Screen’s WCC III Logical Address is GAXXX, where GA = Global Analog and XXX = Global Analog Address
Analog Global Screen