Visara FEP-4600 Planning Guide - Manual (Page 86)

Chapter 7. NULL SNI Networks
7-6 707117-003
Example 3:
For this example, the FEP-4600 is being used to communicate with three different remote
SNI networks. Three CTC connections must be defined, one for each of the remote
connections. This should be done using three CNTLUNIT statements.
RESOURCE PARTITION=((PRODC,3))
CHPID PATH=(1E),TYPE=CNC
CNTLUNIT CUNUMBR=1E00,PATH=1E,UNITADD=((00,1)),UNIT=SCTC,CUADD=0
IODEVICE CUNUMBR=1E00,ADDRESS=(720,1)UNIT=SCTC,UNITADD=00
CNTLUNIT CUNUMBR=1E01,PATH=1E,UNITADD=((00,1)),UNIT=SCTC,CUADD=1
IODEVICE CUNUMBR=1E01,ADDRESS=(721,1)UNIT=SCTC,UNITADD=00
CNTLUNIT CUNUMBR=1E02,PATH=1E,UNITADD=((00,1)),UNIT=SCTC,CUADD=2
IODEVICE CUNUMBR=1E02,ADDRESS=(722,1)UNIT=SCTC,UNITADD=00
Note that whenever you have more than one CU defined between the same local LPAR
and the FEP-4600 over the same CHPID, you must use a different CUADD value to
distinguish between them. (This is a requirement of the architecture, not just a
requirement of the FEP-4600.) In the above example you can see that CUADD numbers
of 0, 1, and 2 are used.
FEP-4600
PRODC
LPAR 3
3 Remote
SNI Networks
CPU