Visara FEP-4600 Planning Guide - Manual (Page 46)

Chapter 3. Support of PU 2.1 Nodes
3-10 707117-003
Local Major Node VTAM Gen Requirements
This section applies to PU2.1 nodes attached using Method 1 described previously,
ESCON host interface using a Luminex ESCON card.
The VTAM gen requirements for PU 2.1 controllers are simple, but some of the details
vary dependent upon what type of APPN node you are attaching. You must define one or
more Local SNA Major Node definitions. Defining each PU 2.1 platform to have its own
Local SNA Major Node definition has the benefit that if you need to take the definition
down to make a change, you will only affect the PU that you need to make the change to.
An example definition for a PU 2.1 LEN platform communicating through the FEP-4600
might look like this:
LOCSNA01 VBUILD TYPE=LOCAL
PU21AIX1 PU CUADDR=300,
MODETAB=TABPU21,
SSCPFM=FSS,
DLOGMOD=LU62,
XID=YES,
MAXBFRU=9
LU062101 LU LOCADDR=0
LU062102 LU LOCADDR=0
LU062103 LU LOCADDR=0
LU062104 LU LOCADDR=0
Note that for LEN APPN nodes connected directly through the FEP-4600, all LUs must
be defined to VTAM. LEN nodes do not report their LUs through the network
automatically.
A definition for a pair of NN or EN will look similar, but without the need for the LU
definitions if VTAM is also genned to be a Network Node or End Node.
LOCAPPN1 VBUILD TYPE=LOCAL
PU21AIX1 PU CUADDR=300,
MODETAB=TABPU21,
DLOGMOD=LU62,
XID=YES,
CPCP=YES
MAXBFRU=9
LOCAPPN2 VBUILD TYPE=LOCAL
PU21AIX2 PU CUADDR=301,
MODETAB=TABPU21,
DLOGMOD=LU62,
XID=YES,
CPCP=YES
MAXBFRU=9