Visara FEP-4600 Planning Guide - Manual (Page 79)

37x5 to FEP-4600 Migration and Planning Guide
707117-003 6-23
If parallel transmission groups are being set up for use by the FEP-4600, then do not
forget to code an explicit route for each transmission group.
If more than one VTAM is defined to be adjacent to the FEP-4600 (a CTC definition was
created), you will need to consider the PATH tables for each VTAM that is directly
adjacent.
There should be no need to modify the PATH tables for non-adjacent subareas, since they
do not have to directly communicate with the FEP-4600.
As for the PATH table of the adjacent 37x5 that the FEP-4600 is communicating with; if
the FEP-4600 is configured with the subarea of the 37x5 it is replacing, then there should
be no need to make any changes.
Example 1:
Following is an example of the changes that would need to be made to the PATH table of
the VTAM that is directly adjacent to the FEP-4600 in the discussion found earlier in this
chapter for the subarea usage requirements of the FEP-4600 (Scenario 3). Reference the
Before and After diagrams found with those scenarios.
VTAM PATH TABLE for VTAM 03 (Before)
PATH0304 PATH DESTSA=04,ER1=(04,1),VR1=1
PATH0314 PATH DESTSA=14,ER1=(04,1),VR1=1
PATH0310 PATH DESTSA=10,ER1=(04,1),VR1=1
PATH0324 PATH DESTSA=24,ER1=(04,1),VR1=1
PATH0322 PATH DESTSA=22,ER1=(04,1),VR1=1
VTAM PATH TABLE for VTAM 03 (After)
PATH0307 PATH DESTSA=07,ER1=(07,1),VR1=1
PATH0305 PATH DESTSA=05,ER1=(05,1),VR1=1
PATH0314 PATH DESTSA=14,ER1=(07,1),VR1=1
PATH0310 PATH DESTSA=10,ER1=(07,1),VR1=1
PATH0324 PATH DESTSA=24,ER1=(05,1),VR1=1
PATH0322 PATH DESTSA=22,ER1=(05,1),VR1=1
VTAM PATH TABLE for VTAM 03 (Alternate Solution)
PATH0305 PATH DESTSA=05,ER1=(05,1),VR1=1
PATH0314 PATH DESTSA=14,ER1=(05,1),VR1=1
PATH0310 PATH DESTSA=10,ER1=(05,1),VR1=1
PATH0324 PATH DESTSA=24,ER1=(05,2),VR1=1
PATH0322 PATH DESTSA=22,ER1=(05,2),VR1=1