Vinpower Digital Xerox LightScribe Series - Manual (Page 54)

54 Xerox LS Duplicator
Change the Setup settings
Most of the internal settings and informa-
tion is stored inside the Setup menu . To
explore and modify them is simple . Below is
an example how to modify the “Auto Start”
setting . Please note that the default setup is
set for optimal performance of the duplicator,
it is unnecessary to change if you are satisfied
with the outcome .
When you turn on your duplicator, after it
has booted up, you should see the following
signifying your duplicator is ready .
Step 1: Use the up or down arrow button to
navigate to the Setup menu .
Step 2: Press the >> button to enter the Setup
menu and you shall see a screen similar to
below:
Step 3: Use the up or down arrow button to
navigate to the Auto Start setting .
Step 4: Press the >> button to enter the
Auto Start setting and you shall see a screen
similar to below:
Step 5: Use the up or down arrow button to
change the value to “Full” .
Step 6: Press the >> button to submit the
change . Once completed, you will be guided
back to the setting menu .
Step 7: Press << button to go back to the
main menu .
Note
This change will only be effective for the
current usage until you power off the
duplicator unless you perform the Save
function under the Utilities menu, or
perform the Shutdown function under the
main menu.
DUPLICATOR 2.20
1.Copy
DUPLICATOR 2.20
11.Setup
Setup
1.Language
Setup
2.Auto Start
Auto Start
Auto
Auto Start
Full
Setup
2.Auto Start
DUPLICATOR 2.20
11.Setup