Vinpower Digital Xerox LightScribe Series - Manual (Page 38)

8 Xerox LS Duplicator
Section 2: Selecting the Print
Source of the duplicator as the
Reader.
When you turn on your duplicator, after it
has booted up, you should see the following
signifying your duplicator is ready .
Step 1: Use the up or down arrow button to
navigate to the Select Source menu .
Step 2: Press the >>button to enter the “Se-
lect Source” menu and you shall see a screen
similar to below:
Step 3: If you plan to use the Reader as the
source, use the up or down button to locate
Drive 0 (1st drive) and press the >> button to
select it .
If you would like to use one of the Writers as
the source, use the up or down button to lo-
cate Drive 1 or any other corresponding drives
located on the duplicator and press the >>
button to select it .
Once the source has been selected, you will
be guided to the Main menu . You should see
the following screen:
DUPLICATOR 2.20
1.Copy
DUPLICATOR 2.20
9.Select Source
Drive 0 Port x.x
ASUS DVD-E818A
Drive 0 Port x.x
ASUS DVD-E818A
Drive 1 Port x.x
Pioneer DVD-RW DVR-1
DUPLICATOR 2.20
9.Select Source
If the drive you’ve selected is
the same as the original source,
the duplicator will NOT respond
to the >> button. Please press
<< button to go back to the
main menu.
Note