Verilink Productivity 500 (34-00236) Product Manual - Manual (Page 95)

Appendix C 500 TA Page 95
S26= RTS to CTS time Range: 0-255 default (1)
Units = 1/100 seconds
&Cn Data Carrier Detect n = 0 Always On
n = 1 Tracks Connection (async only)
n = 2 always except during S10
disconnect (async only)
&Dn Data Terminal Ready (DTR) n = 0 Ignore DTR (async / sync)
>
n = 1 Recall ACU (async only)
n = 2 Hangup - auto answer disabled
while DTR down (async only)
n = 3 Hangup - reset port
n = 9 DTR Dial
&Ln Persistent DTR Dialing n = 0 Disable
n = 1 Enable
&Mn Sync mode n = 0 Async
n = 1 Sync - DTR disc delay (S25)
n = 2 Sync - DTR dialing (auto answer
disabled while DTR down)
&Rn Clear to Send (CTS) n = 0 CTS follows RTS
n = 1 CTS always on when on-line
&Sn Data Set Ready (DSR) n = 0 DSR always on
n = 1 DSR on after protocol installed
except test modes
&Yn Select Powerup Stored Profile n = 0 Select stored Profile 0 upon
powerup or DTR reset
n = 1 Select Stored Profile 1 upon
powerup or DTR reset
&Zn= Store Telephone Number n = 0-9
n = 0-40 characters (0-9,#,*)
\Qn Flow Control n = 0 Disable flow control
n = 1 Enable bidirectional XON/XOFF
flow control
n = 2 Enable unidirectional CTS flow
control
n = 3 Enable bidirectional RTS/CTS
flow control
n = 4 Enable unidirectional
XON/XOFF flow control
CMD DESCRIPTION POSSIBLE VALUES