Verilink Productivity 500 (34-00236) Product Manual - Manual (Page 64)

Page 64 500 TA Call Placement
CALL TERMINATION
The 500 TA will terminate the call when any of the configured call termination
conditions occur. These conditions are listed in
Table 5 .
Table 5 Call Termination
Termination
Condition
Selective
Disable?
Notes
Any Key Abort No Only during the connect sequence,
before the connection is established.
ATH Command No 500 TA must be in the command mode.
Loss of DTR Yes Depends upon S25.
Call Placement
Failure
Partial Due to no dial tone, busy signal, or no
carrier; timeout set in S7.
Rate Adaption
Protocol Link
Establish Failure
No Unable to establish the rate adaption
protocol.
Protocol Disc.
Request Rcvd
No A disconnect request was received from
remote TA.
Protocol Error Detected No Fatal protocol error detected.
500 TA Reset or
Powered Off
No 500 TA automatically disconnects when
reset or powered off.