Thermon TraceNet TCM 18 - Manual (Page 61)

The recommended typical list of cleaning materials follows:
Materials Comment
Lockout and tag out safety tags
Dry lint free cloths
Cleaning agent
Medium grit sandpaper
Touch up paint
Machine oil
Grease
Electrical tape Refer to specific panel materials list for
any tapes being used. Use only Thermon
approved or equivalent materials.
Damp cloth To avoid electrostatic discharge, clean
window with damp cloth only.
Recommended Visual Inspection Procedures
The interior and exterior of the control and monitoring panel should be inspected as
follows:
• Inspect door and /or heat sink gaskets for water intrusion as indicated by
mineral deposits and rust. Where feasible replace any gaskets which ap-
pear to be faulty.
• Survey panel exterior and interior for dust, lint, moisture, or foreign residue.
Remove any such residue with the lint free cloth material. Heavy residues
may be addressed with wood scrapers and a cleaning agent. Do not soak
parts with cleaning agent but only use dampened cloths in removing heavy
residues. Excessive application of cleaning agents can damage compo-
nents.
• Check for panel corrosion and scratches. Remove corrosion and prepare
any damaged areas with sandpaper. Repaint with the approved primer and
touch up paint.
57 PN 50316_0514