Thermon TraceNet TCM 18 - Manual (Page 42)

The flashing cursor now moves to the next line which
allows the operator of the TCM18 to program the
amount of time in minutes(soft start time) over which
the TCM18 will ramp up the power from 20% to 100%
power clamp level. This option applies to SOFT START
and PROPORTIONAL control modes. Press the UP or
DOWN arrow keys to enter a new value and press EN-
TER to accept.
PROG plus
CONFIG
5
The flashing cursor now moves to the next display
screen which allows the operator to set the beginning
circuit number to a value from 1 to 82 on this particular
TCM18 control and monitoring module. Press the UP
or DOWN arrow keys to enter a new value and press
ENTER to accept.
The flashing cursor now moves to the next line which
allows the operator of the TCM18 to program the
preferred units (
◦ F or ◦ C) in which the temperatures
measured by the RTD(s) will be displayed.
Note that all of these values are global and apply to all
eighteen circuits on this TCM18 controller.
Press the PROG key at any point to exit for this se-
quence. If left in the program mode, the TCM18 will
after a short wait, automatically return to the SCAN
mode.
PROG plus
HEATER
ENABLE This display screen allows the programming of the
heater operating status for each of the eighteen circuits
individually or for all circuits (in the case the value is
identical). The heater operating status selectable op-
tions are:
PN 50316_0514 38