Thermon ET-7C - Manual

Tools Required
1
Applications
ET-7C
Installation Instructions
2 2 Tape Strips
3 1 RTV Tube
Item Qty Description
1 1 End Cap
Kit Contents:
The ET-7C Kit is used for end circuit termination of FP-BN con-
stant watt heating cable.
Due to the risk of electrical shock, arcing and fire caused by product
damage or improper usage, installation or maintenance, a ground-fault
protection device is required.
Installation must comply with Thermon requirements and be installed
in accordance with the NEC, CEC, or any other applicable national
and local codes.
Component approvals and performance ratings are based on the use
of Thermon specified parts only.
Keep ends of heating cable and kit components dry before and during
installation.
Warnings
2
3
End Termination Kit
IP66 NEMA/Type 4X
Ordinary & Hazardous Locations
Listed Heat Tracing Cable System 137M
Certifications vary by cable type. See product
specification sheets for additional information.
Certifications/Approvals
4
4 1 Lug
IECEx