Pure mode – Teletronics EZMesh User Manual

Page 46

User Guide - EZMesh Full Duplex Mesh Network Access Point

Setup Trunk and Native VLAN Mode

Step 1. Login to the Ethernet/VLAN

Step 2. Check “Trunk and Native VLAN” radio button under the VLAN Ethernet
Mode

Step 3. Click Save Setting and Apply

Pure Mode

Pure Trunk - Only tagged (VLAN IDs and priority included) frames entering the
Ethernet port will be accepted. Egress frames will exit the Ethernet port unaltered.
If the frame leaving the Ethernet port contains a VLAN tag, it will be transmitted
with that same tag. If the frame leaving the Ethernet port does not contain a VLAN
tag, the frame with be transmitted without a tag. In this mode, the MeshAP must
be connected to a VLAN capable device and the port on that device must be
configured as a Trunk port.

Setup Pure Mode

Step 1. Login to the Ethernet/VLAN

Step 2. Check “Pure” radio button under the VLAN Ethernet Mode

TELETRONICS INTERNATIONAL, INC.

- 42 -