Wireless lan access – Teletronics EZMesh User Manual

Page 19

User Guide - EZMesh Full Duplex Mesh Network Access Point

Step 2. Change PC IP address to 192.168.1.XXX Subnet mask: 255.255.255.0

Step 3. Access MeshAP via WAN Ethernet Port

Make sure the Ethernet cable is properly connected to both MeshAP - WAN

Ethernet Port and PC - Ethernet Port. (Connect via PoE Injector)

Note: Please review the Hardware installation Guide for more information.

Step 4. Open a Web Browser and type 192.168.1.8 to access the MeshAP Access Point.

Step 5. User Name: admin

Password: admin

Click "OK

Wireless LAN Access

Step 1. Make sure the MeshAP unit is Powered On and Ready. Once it is powered on, it

takes about 35 seconds for the MeshAP unit to completely get booted and be ready

for service and configuration.

Use wireless WLAN utility application on PC to scan for SSID: mymesh. Make

sure the SSID: mymesh unit has the correct Mac address.

TELETRONICS INTERNATIONAL, INC.

- 15 -