Teletronics EZMesh User Manual
Page 23
User Guide - EZMesh Full Duplex Mesh Network Access Point
Step 4. Assign IP Address to Mesh Manager unit.
IMPORTANT: The default IP Address for Mesh Manager is 192.168.1.254
The IP address will be automatic assign to Mesh Manager unit once the “MeshAP Working
Mode Change from “Mesh Station” to “Mesh Manager”
There are two modes available to assign IP address to the Mesh Manager unit
DHCP Mode – Auto Assign an IP address to Mesh Manager unit via Network
Gateway/Router.
Static Mode – Assign IP address manually to Mesh Manager unit
Step 4
o
Replace the default IP address to an IP address of your choice that could
be reached from the existing network. You can also select an IP address
provided by the ISP as your MeshAP IP Address
o
Replace the default Subnet Mask with the one belonging to the above IP
address.
o
Enter the Gateway IP of the above IP address or the IP address provided
by your ISP as a Gateway IP address. (For Remote Management)
IMPORTANT: Make sure the gateway address and the IP address of the unit are under the
same network. If not, the unit may not be able to log-on because the network is not
logically connected.
TELETRONICS INTERNATIONAL, INC.
- 19 -