Installing the ezmesh access point on a wall, Installing the meshap access point on a wall – Teletronics EZMesh User Manual

Page 16

User Guide - EZMesh Full Duplex Mesh Network Access Point

12. Use a level to verify that the top edge of the pole clamp subassembly is horizontal, and

tighten its adjustment screws.

Installing the EZMesh Access Point on a Wall

Figure 3-3
EZMesh with wall mounting kit installed

1. Use the mounting plate as a template to mark four screw hole locations on your

mounting surface.

2. Mount the mounting plate on the back of the enclosure with two screws.

3. Mount the unit on the wall with 4 screws.

IMPORTANT: The EZMesh must be mounted level. A circular level is attached to assist
with this.

TELETRONICS INTERNATIONAL, INC.

- 12 -