Teletronics WLAN Inter-Building AP XI-1500 User Manual
Teletronics Communication

Sep./24
th
/2000
1
11Mbps Wireless Inter-building Access Point
Quick Start Guide
Version 2.9.0
The next-generation wireless LAN device – 11Mbps Wireless Inter-building Access Point,
are specially designed for Point-to-Point and Point -to-Multipoint applications, offering
campus-wide connections between buildings at a speed of up to 11Mbps. Fully compliant
with IEEE802.11b standard, the Wireless Inter-building Access Point provides powerful
features such as Windows-based Access Point Utility, WEB Management, WEP, Access
Control, SNMP and more.
Package Content
11Mbps Wireless Inter-building Access Point….. .x1 AC Power Adapter….. .x1
Default Dipole Antenna ……………. ……………x2 AP Stand………………x1
Product CD or Floppy Diskette ………………… .x1 Quick Start Guide……. x1
NOTE: If any of the above items are missing or damaged, please contact your local dealer
for support.
Installing the Wireless Inter-Building Access Point
n Connect the two dipole antennas to the connectors on the two sides of the Access
Point. For inter-building application, however, it is sufficient that an antenna is used.
You may control which antenna to do Tx/Rx for better performance (to avoid
interfering signals). The configuration is as follows:
Ø Assign an IP Address for the Wireless Inter-Building Access Point. (For
instructions please refer to page 6.)
Ø Telnet into the Access Point.
Ø Type the command “set antenna”. The following screen shows up.
Ø Enter “set antenna a_only/b_only”. (Antenna A labeled “ANT. A” is on the
back panel of the Access Point.) (Default value: Diversity)
Ø Type the “save ” and “reset” to make the configuration take effect.