Teletronics EZMesh - Manual (Page 28)

User Guide - EZMesh Full Duplex Mesh Network Access Point
Note: “Minimum Mesh Link SNR” is 24dB. This setting could not be change to ensure the
routing protocol is function property under the Auto mode.
*SNR - Signal to Noise Ratio
Note: The grayed out area is the default IP address and subnet mask for the unit. This
setting should be used to access the MeshAP Station unit if the MeshAP Station unit lost
the mesh link connection with the Mesh Manager unit.
Mesh ID
The Mesh ID is a unique identification for a mesh network. Only MeshAP Access Points
with the same Mesh ID will be able to associate with each other on the mesh network.
Step 5. Replace the default Mesh ID with a preferred name that is identical with the Mesh
Manager. MeshAP Stations MUST use the same Mesh ID in order to be managed
by the Mesh Manager unit.
Step 6. Update Station Name. (The Station Name is NOT required, it is recommended for
easy identification of each Station.)
Step 7. Update Station Location. (The Station Location is NOT required, it is
recommended for easy identification of each Station.)
Step 6
Step 7
Step 8
Step 8. Click "Save Settings and Apply" to confirm changes.
TELETRONICS INTERNATIONAL, INC. - 24 -