Teac DR-22WL Reference Manual - Manual (Page 17)

TASCAM DR-22WL
17
4 – Recording
Selecting a folder to store files
The DR-22WL allows you to specify folders to store the recorded
files. The recorded file will be saved in the current (currently
selected) folder. (See “5 – Operating files and folders (browse
screen)” on page 26.)
If no folder is specified, the file will be stored in the
“MUSIC”
folder.
Recording format settings
(FORMAT/SAMPLE/TYPE)
Select the desired audio file type before you start recording.
1. Press the /MENU/8 button to display the
REC page in
menu screen.
2. Use the F2 and F3 buttons to select (highlight) the
FORMAT item and press the F4 button.
Open the parameter list for the
FORMAT
item.
3. Use the F2 and F3 buttons to select (highlight) the
file type.
Options:
BWF 16bit
,
BWF 24bit
,
WAV 16bit
(default value),
WAV 24bit
,
MP3 32k
,
MP3
64k , MP3 96k , MP3 128k , MP3 192k ,
MP3 256k , MP3 320k
NOTE
• The WAV format offers higher quality recording than MP3
files;
• On the other hand, the MP3 format can record for longer
hours.
• With MP3 format, recording with higher values offers better
quality.
• Cue marks in WAV file that supports BWF (Broadcast
Wave Format) can be used in BWF compatible devices and
computer softwares.
4. Press the F4 button to finalize the setting and return to
the item selection mode.
5. Use the F2 and F3 buttons to select (highlight) the
SAMPLE RATE item and press the F4 button.
Open the parameter list for the
SAMPLE RATE
item.
6. Use the F2 and F3 buttons to select (highlight) the
sampling rate.
Options: 44.1k (default value), 48k , 96k
NOTE
96k cannot be selected for a MP3 format file.
TIPS
Selecting the WAV 16bit and 44.1kHz will allow you to
record in CD-quality.
7. Press the F4 button to finalize the setting and return to
the item selection mode.
8. Use the F2 and F3 buttons to select (highlight) the
TYPE item and press the F4 button.
Open the parameter list for the
TYPE
item.
9. Use the F2 and F3 buttons to select (highlight) either
the stereo file or mono file.
Options:
SEREO
(default value),
MONO
NOTE
• When
MONO
is selected, the L-channel signal will be
recorded.
• Selecting the WAV format
MONO
will extend the recording
hours by two times than the
STEREO
type, allowing for
longer recording hours.
10. Press the F4 button to finalize the setting and return to
the item selection mode.
11. Press the /MENU/8 button to return to the home screen.