Teac DM-4800 Effect List - Manual (Page 6)

Effect parameter list
TASCAM DM-4800 Effect list
Parameter Indicator Range Description Remarks
Output wet
cross feed Wet X-Feed 0% - 100% (1% steps) Specifies pan for L/R wet
channel outputs. With 0%, L channel wet
signal is output from L
channel, and R channel
wet signal is output
from R channel. With
100%, L channel wet
signal is output from R
channel and R channel
wet signal is output
from L channel.
Mixture Mixture 0% - 100% (1% steps) Specifies mix ratio of
dry feedback delay sig-
nal and LFO modulation
signal.
MONO FLANGER FX2.0
This flanger effect features mono-in and stereo-out.
It uses the same algorithm as the chorus effects, and the parameters are identical to the mono chorus pa-
rameters.
Table 1.3: Mono Flanger parameters
Parameter Indicator Range Description Remarks
LFO rate LFO Rate Freeze, 0.01 Hz - 30.00 Hz (0.01 Hz steps) Specifies LFO frequency.
LFO depth LFO Depth 0.0% - 100.0% (0.1% steps) Specifies LFO modula-
tion depth.
Pre-delay Pre-Delay 0 ms - 500 ms
(0 ms - 9.99 ms: 0.01 ms steps;
10 ms - 99 ms: 1 ms steps;
100 ms - 500 ms: 10 ms steps) Specifies time between
onset of original sound
and onset of the effect
sound. Using this parameter
enables you to make
interesting and detailed
settings based on subtle
changes due to phase
cancellation.
Feedback
amount FeedbkAmt 0% - 90% (1% steps) Specifies amount of
delay line output signal
returned to delay line
input.
Feedback
inversion InvertFbk Off, On Determines whether
or not feedback path
output signal will be
inverted.
LFO waveform
type LFO Type Off, Sine, Triangle, Sawtooth Up, Sawtooth
Down, Square Specifies LFO waveform
type.
LFO softening LFO Smooth 0.0% - 100.0% (0.1% steps) Specifies low-pass filter
coefficient applied to
LFO waveform. This parameter improves
unnatural sound at
discontinuous points by
smoothening out edges
of sawtooth or square
waveform.
Dry delay DryDly
(Thru 0) 0.0% - 100.0% (0.1% steps) Specifies delay of dry
signal that simulates
“ through zero” flanging.