Teac DM-4800 Effect List - Manual (Page 15)

Effect parameter list
TASCAM DM-4800 Effect list
1
Parameter Indicator Range Description Remarks
Tap 8 gain
amount Tap8Gain 0% - 100% (1% steps) Specifies amount of
audio signals feedback
from this tap to delay
input.
DISTORTION FX2.0
This mono distortion enables pre-amp or power amp
modeling.
Table 1.9: Mono Distortion parameters
Parameter Indicator Range Description Remarks
Pre-amp gain PreAmpGain 0.00 - 11.00 (0.01 steps) Specifies input gain at
pre-amp section. With the maximum set-
ting (11.00), the input
signal gain is multiplied
110 times.
Pre-amp drive PreAmp
Drive 0.00 - 11.00 (0.01 steps) Sets distortion at pre-
amp section.
Power amp
gain PwrAmp
Gain 0.00 - 11.00 (0.01 steps) Specifies input gain at
power amp section. With the maximum set-
ting (11.00), the input
signal gain is multiplied
110 times.
Power amp
drive PwrAmp
Drive 0.00 - 11.00 (0.01 steps) Sets distortion at power
amp section.
Routing Routing PreAmp+PwrAmp, PreAmp->PwrAmp,
PwrAmp->PreAmp, PreAmp, PowerAmp Sets distortion routing.
Asymmetry Asymmetry –100.0% - 100.0% (0.2% steps) Adjusts DC offset at
power amp section.
Morph Morph 0.0% - 100.0% (0.1% steps) Specifies mix bal-
ance between pre-
amp distortion and
power amp distortion
when Routing is set to
PreAmp+PwrAmp. If the
value is closer to 0%,
more power amp distor-
tion, and if it is closer
to 100%, more pre-amp
distortion.
Pre EQ type PreEq Type Parametric, Shelving, Stack, Big Bottom,
Wide, Phat Mid Selects a preset com-
bination of pre filter
frequency and Q.
Pre low filter
gain Pre Low –15 dB - +15 dB (0.1 dB steps) Specifies pre low filter
gain.
Pre mid filter
gain Pre Mid –15 dB - +15 dB (0.1 dB steps) Specifies pre mid filter
gain.