Teac DM-4800 Effect List - Manual (Page 17)

Effect parameter list
TASCAM DM-4800 Effect list
1
PHASER FX2.0
The stereo phaser offers five LFO waveforms.
Table 1.11: Stereo Phaser parameters
Parameter Indicator Range Description Remarks
LFO rate LFO Rate Freeze, 0.01 Hz - 30.00 Hz (0.01 Hz steps) Specifies LFO frequency.
Negative (Yin)
LFO depth Yin Depth 0.0% - 100.0% (0.1% steps) Specifies modulation
depth of negative side
of LFO.
Positive (Yang)
LFO depth Yang Depth 0.0% - 100.0% (0.1% steps) Specifies modulation
depth of positive side of
LFO.
Master
resonance MasterRes 0.0% - 200.0% (0.1% steps) Sets relative balance
between negative and
positive sides.
LFO waveform
type LFO Type Off, Sine, Triangle, Sawtooth Up, Sawtooth
Down, Square Specifies LFO waveform
type.
Negative (Yin)
stage Yin Stages 1 stage - 32 stages (1 stage steps) Specifies the number of
stages for all-pass filter
cascaded on the nega-
tive side.
Positive (Yang)
stage Yang
Stages 1 stage - 32 stages (1 stage steps) Specifies the number of
stages for all-pass filter
cascaded on the positive
side.
Negative and
positive mix
balance Yin/Yang
Mix 0% - 100% (1% steps) Sets relative balance
between negative and
positive sides before
mix.
Negative (Yin)
resonance Yin Res 0.0% - 100% (0.1% steps) Specifies resonance
(filter efficiency) of each
all-pass filter stage.
Negative (Yin)
phase inversion Yin Invert Off, On Determines whether or
not the output phase of
the audio path of nega-
tive all-pass filter will be
inverted.
Positive (Yang)
resonance Yang Res 0.0% - 100% (0.1% steps) Specifies resonance
(filter efficiency) of each
all-pass filter stage.
Positive (Yang)
phase inversion Yang Invert Off, On Determines whether or
not the output phase of
the audio path of posi-
tive all-pass filter will be
inverted.