Sundance SMT321 - Manual (Page 39)

7 User Manual
The following section describes the use of the SMT321 on a Sundance Carrier using L3
server.
When the application for the SMT321 is generated and run it will start by configuring the
FPGA and then asking the user which SMT321 is present (high frequency or low
frequency). The start up screen will show:
Start FPGA Configuration ...
The FPGA is then configured and when it is done the following messages is shown:
FPGA Configuration Done
.............................................................................................................................................
.............................................................................................................................................
......
After the message is shown the user is prompted to select which SMT321 is present on
the board.
* Specify type of SMT321:
0:Low Freq
1:High Freq
After the user has selected the board configuration a main menu will be displayed.
===================================
| SMT321 Test Software v1.0 |
| Main Menu |
===================================
1: Read SMT321 Firmware Version
2: Write to the SMT321 Scratch Register
3: Read the SMT321 Scratch Register
4: Read SMT321 Temperatures
5: Read the SMT321 Serial Number
6: Read all the SMT321 Voltages
7: Write any command to SMT321
8: Read the SMT321 dip switches