Seaward 350 PrimeTest - Manual (Page 48)

PrimeTest 350 Operating Instructions
- 47 -
“Barcode comments” option allows general text fields
to be scanned as user comments at the end of the test.
Note: If data entry is set to barcode or RFID, the
unit will automatically try to connect to a
barcode scanner or RFID wand via the
internal Bluetooth module – if neither is
available this feature is simply draining the
batteries un-necessarily. In this instance it is
recommended that the unit be set to Keypad
only.
10.2.5 Backlight Mode
The backlight on the PrimeTest 350 can be set to
either, never come on, stay on permanently or come
on in Power Save mode. Power save mode ensures
that the backlight comes on when a key is pressed and
stays on for several seconds before switching itself off
again. Use the left/right arrow keys to set.
10.2.6 Type of User
The user type can be set to Novice or Expert. For
Novice users, additional help prompts are provided
during test sequence.
10.2.7 Tones
The Tones (F3) key will select a screen which will
allow the various tones to be set up, i.e. Beep on Key
Press or Beep on Warning etc. Use up/down arrow
keys to highlight desired function and the left/right
arrow keys to set.
10.3 Change User
The PrimeTest 350 has a password protected User
system to prevent unauthorised modifications to the
configuration.
There are two levels of access. When logged in as
Admin full access is available to all configuration
options as shown below.