RLE LD1500 V.3.1 - Manual (Page 20)

20 LD1500 User Guide 800.518.1519
3 Installation
must now use the new IP address and reset your computer to its original IP address and
Subnet Mask.
5 Change the IP address of your computer back to its original IP address. If the computer was
configured as DHCP (the network domain controller assigns an IP address) return it to this
state. This may require assistance from your IT Department, or you may need to consult the
computer's manual
6 The computer and the LD1500 are now both configured to communicate on the network.
Both should be accessible via the network. Connect the PC and the LD1500 to the network.
From the PC Web browser, type in the IP address of the LD1500. Enter the user name and
password as stated above to verify network access to the LD1500.
3.4.1.2 Set the LD1500’s IP Address using an EIA-232 Connection
To use the EIA-232 interface:
1 Connect the EIA-232 port (P4) on the LD1500 to a terminal or PC running terminal
emulation software (such as HyperTerminal) with a 9-pin male-female straight through
serial cable.
2 Set the appropriate communication port to 9600 baud, 8 data bits, no parity, 1 stop bit
(9600/N/8/1), and no software or hardware flow command.
3 Once the terminal emulation software starts, type ? and press ENTER on the keyboard and
the Main Menu should appear. If the Main Menu does not appear, check the communication
settings and make sure the unit is powered on.
4 From the Main Menu type “netcfg” to select the Network Configuration Menu.
5 Enter the new IP address for the LD1500 by typing ip xxx.xxx.xxx.xxx where
xxx.xxx.xxx.xxx is the new IP address of the unit. Separate each field with a decimal point
— for example, type ip 10.0.0.50 .
6 The LD1500 will erase a memory block and copy data to Flash memory before rebooting.
7 The LD1500 IP address is now set and the LD1500 can be accessed through a Web browser
using the new IP address.
8 Repeat steps 4-7 to change the Subnet Mask and Def Route, if needed, using the commands
nm xxx.xxx.xxx.xxx to change the Subnet Mask and dg xxx.xxx.xxx.xxx to change the
default gateway.