RLE 10K V.2.5.a - Manual (Page 41)

rletech.com SeaHawk 10K User Guide 41
A
P P E N D I X
C HAPTER 0
C
ONFIGURATION
R
EFERENCE
This chapter provides a complete listing of all possible configuration and address settings that
can be made using the DIP switches in blocks SW1 and SW2.
The configuration of a stand-alone SeaHawk 10K can be performed using the DIP switches on
the front panel. If the SeaHawk 10K will be connected to a Modbus-equipped monitoring
system, some of the configuration can be performed using the registers. Chapter 2 describes
how to install and configure the SeaHawk 10K and refers to specific DIP switch settings
where appropriate. Information about Modbus communications can be found in Chapter 4.
A.1. DIP Switches
The SeaHawk 10K contains two blocks of DIP switches.
Figure A.1 General Dip Switch Settings