RLE 10K V.2.5.a - Manual (Page 15)

rletech.com SeaHawk 10K User Guide 15
2 Installation and Configuration
2.4. Establish Physical Connections
Figure 2.3 Relay Output (TB1) and Sensing Cable Connection (TB2)
Figure 2.4 Power and Communications Connections (TB3 and TB4) and Termination Jumper
(JMP)
2.4.1 TB1: Summary Relay (optional)
Terminal Block 1 is a Form C relay output. This relay enables alarm notification through a
local or remote panel, master controller, or BMS whenever a leak, cable fault, or cable
contamination is detected.
1 Insert the wires into the appropriate slots on TB1 to connect the relay output to the desired
panel or controller.
Figure 2.5 Relay Output Connection TB1
Relay Output
Sensing Cable
Connection
AC/DC Power Connections (2)
and
EIA-485 Communications Ports (2)
Termination Jumper
Earth Ground
for use with
AC Power