RGBLink VSP 9516S User Manual - Manual (Page 129)

VSP 9516S User Manual 129
4. Remove all the screws on the back panel .
5. Lift the top cover and back panel.
Caution: Do not touch any electronic components inside the VSP 9516S.
Doing so could damage the processor. Electrostatic discharge (ESD) can
damage IC chips even though you cannot feel it. You must be electrically
grounded before proceeding with maintenance. A grounding wrist strap is
recommended.
6. Pe
rform the desired maintenance procedure. See ―Install the SDI Optional
Module‖ in Part 2.
Part 2: Install the SDI Optional Module
Install an optional SDI input board in the VSP 9516S as follows:
Warning: Changes to electronic components must be performed by
authorized service personnel only.
1. Open the processor. See ―Take Apart the VSP 9516S‖ in Part 1.
2. On the main board port 2, locate SDI input board port 1, align and gently
apply pressure to mate input board with main board, as shown in Figure 2.