How to realize led display connection, System setup and operation – RGBLink VSP 9516S User Manual User Manual
Page 100
6. System Setup and Operation
How to Realize LED Display Connection
VSP 9516S User Manual 100
How to Realize LED Display Connection
VSP 9516S can realize three connections as follows: connecting the Port D or Port U of
one sending card to LED display, connecting the both Port D and Port U of one sending
card to LED display, connecting the Port D and Port U of two sending cards to LED display.
The following are the detailed operation steps of the three connections.
1. Connect the Port D or Port U of One Sending Card to LED Display
Here we take No.1 sending card, port U1 for example. (Note: No.1 sending card
corresponding to port D1 and port U1, No.2 sending card corresponding to port D2 and
port U2.
(1) First, make sure that the device is in normal operation. The red power indicator lights
when the device has power supply and the green signal indicator lights when device
has signal input.
(2) Choose the input signal, for example, choose DVI.
(3) Connect the cable to Port U1.
(4) Turn the knob, choose
knob, choose the sending card type, for example, choose Linsn (VSP 9516S can only
support Linsn and Colorlight sending card). Shown as follows:
（5）Turn the knob, choose
knob, choose NO.1, push the knob to confirm.
>
SENDING CARD TYPE COLOR LIGHT
SENDING CARD NO. NO.1
BRIGHTNESS 50%
QUICK CONNECTION >>
*
SENDING CARD TYPE LINSN
SENDING CARD NO. NO.1
BRIGHTNESS 50%
QUICK CONNECTION >>