RGBLink MVP 320 Quick Start - Manual

MVP 320 – Quick Start
VIEWSIZE THE WORLD
NOTE
For full installation, configuration, and operation details, refer to the
MVP 320 user manual, which is available at www.rgblink.com.
This guide provides quick start instructions for an experienced installer
to set up and operate the MVP 320.
Installation and cabling features
Step 1-Mounting
Turn off or disconnect all equipment power sources.
Step 2-Install input
Video Input
Install input modules in need. MVP 320 support 4
k i n ds of i n p u t m o d ul e s , s u c h a s c om p os i t e ,
component, VGA and DVI. Each module has two
inputs except component just have one.
Inputs number: 4 to 72;
MVP 320 Quick Start
Rev 1.1
Page 1 of 2
Address:S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.com
Graphic input
Inputs graphic: DVI / VGA;
Interface：DVI ：DVI-I(Female），
RGB：DB15；
Resolution：640x350,640x400,720x400,
640x480,848x480, 00x600,848x480,
1024x768,1152x864,1280x720, 1280X768,1280X960,
1280x1024,1360x768,1400x1050,1440x900,
1600x1200,1680x1050,1792x1344,1856x1392,
1920x1080,1920x1200
Inputs number: 4 to 72;
Inputs graphic: DVI / VGA;
Input Video: Composite, Component;
Interface：BNC；(Component use RCA);
Step 3-Install output
Outputs number: 4 to 72;
Each output module support 2 DVI-I output, from the
DVI-I interface output DVI and VGA together.
Graphic output
Output graphic: DVI + VGA;
Interface：DVI-I (Female);
Resolution：
800x600,1024x768,1280x720,1280x1024,1360x768,
Remote control
MVP 320 just support remote software control by RS
232 or TCP/IP (IP based), user can work with the
software run on the Windows based system or
console to set up remote control.
Remote control can manage display modes, display
window, video control and schedule, all the operation
can finish by the remote software interface, which is
very user friendly.
Step 1-login
Run the software and for the user login interface, input
ADMIN as user name, keep password as blank if for
first login. Else input the right user name and password
which set up by administrator.
Step 2-setup communication
Open “Communication Set”, if you choose NET for
connection, please click “Choose NET for connection”,
the default IP address of the equipment is
192.168.1.65, port number is 1024. If you choose
Serial ports for connection, please choose the right
COM port, the default Baud rate is 9600. Click
“Confirm” after choosing.
1440x900, 1600x1200,1680x1050, 1920x1080,
1920x1200, all refresh rate in 60Hz;