RGBLink VSP 9516S User Manual - Manual (Page 106)

6. System Setup and Operation
How to Realize LED Display Connection
VSP 9516S User Manual 106
3. Connect the Port D and Port U of Two Sending Cards to LED Display
(1) First, make sure the device is in normal operation. The red power indicator lights when
device has power supply and the green signal indicator lights when device has signal
input.
(2) Choose the input signal, for example, choose DVI.
(3) Connect four cables to Port U1, Port D1, Port U2 and Port D2 respectively.
(4) Connect Port D1 and Port U1 of No.1 Sending Card to LED display, the settings are
same as ―Connect the Port D and Port U of One Sending Card to LED Display‖.
(5) Same as above, connect Port D2 and Port U2 of No.2 Sending Card to LED display.
(6) Turn the knob, choose , push the knob to confirm, turn the
knob again, choose , push the knob to confirm, turn the knob,
choose NO.2, push the knob to confirm.
(7) Turn the knob, choose , push the knob to confirm. Turn the
knob, choose , push the knob to confirm, and enter to the
to the next level menu, the OLED module show as follows:
SENDING CARD TYPE LINSN
> SENDING CARD NO. NO.2
BRIGHTNESS 50%
QUICK CONNECTION >>
SENDING CARD TYPE LINSN
SENDING CARD NO. NO.2
BRIGHTNESS 50%
> QUICK CONNECTION >>