RGBLink VSP 198CVS User Manual - Manual (Page 92)

6. System Setup and Operation
How to Set up the SPLIT
VSP 198CVS User Manual 92
How to Set up the SPLIT
SPLIT is used when multiple VSP 198CVS are used in cascade mode.
When do cascade, connect the signals to the signal distributor first, and then
connect from the outputs of the signal distributor to each input of VSP
198CVS.
The operations are as follows:
Push the SPLIT button, the button LED light will turn on, and enter the split
function menus. Turn the knob, and choose ―SPLIT‖, choose ―ON‖ to enable
the split function, menus are as follows:
H TOTAL: LED screen Horizontal total size.
V TOTAL: LED screen Vertical total size.
H POS: This device display image Horizontal size.
V POS: This device display image Vertical size.
H SIZE: This device display image Width setting.
V SIZE: This device display image Height setting.
RESET: If image quality distorts by improper operation, it can be recover by
factory reset.
Save the parameters after setting.
Following is the example of cascade multiple VSP 198CVS for mapping.
— >SPLIT ON
H TOTAL 1920
H TOTAL 1080
H POS 0
— >V POS 0
H SIZE 1920
V SIZE 1080
RESET