RGBLink VSP 198CVS User Manual - Manual (Page 90)

6. System Setup and Operations
How to Realize Single Image Switching
VSP 198CVS User Manual 90
How to Realize Single Image Switching
Boot the system default CV1 to the current input source, if need seamless
switching other source such as DVI, push DVI button, OLED module show
as follows:
CV1 button light turns off after pushing DVI button. DVI button light will be
on if the DVI signal is effective and stable. And if the DVI signal is invalid or
no input, DVI button light will flash.
The same method can switch the signals among CV2, VGA1, VGA2, DVI,
HDMI, SDI.
Note
Only cut is supported among the switch of CV1,
CV2, VGA2, HDMI and SDI.
SOURCE SELECT:
>DVI SOURCE SELECT:
->DVI