RGBLink VSP 198CVS User Manual - Manual (Page 108)

6.
System Setup And Operation
How to Realize LAN Remote Control Settings
VSP 198CVS User Manual 108
Secondly refer to router ’s instruction (user manual specification), and find out router’s
default network segment.
If router ’s default network segment is 192.168.0.1, then it is same to processor IP address
segment, open up windows control software and user can directly control on VSP
198CVS.
If router ’s default network segment is 192.168.1.1, then user need to change router’s
default gateway or change processor ’s IP, both methods are available, but we suggest to
change processor ’s IP.
Method one: Change processor ’s IP.
Push the MENU button, and go into items as below image shows. Change processor ’s IP
to be 192.168.1.100, confirm and restart the processor, then user can directly control on
VSP 198CVS via windows control software.
Method two: Change router ’s gateway.
Type in 192.168.1.1 on the browser and go into router setting.
Type in default account and code (please refer to the router user manual for the
information).