RGBLink VSP 198CVS User Manual - Manual (Page 43)

4. Menu Orientation
MENU
VSP 198CVS User Manual 43
HDMI ADJUST:
ANTI-ALIAS: If there is sawtooth when input SDI signal, user can do
anti-alias processing by modify STEP_1 to STEP_7, and different STEP
with different effects. System default STEP_1.
RESET: If image quality distorts by improper operation, it can be recover by
factory reset.
Image quality settings.
ADC ADJUST:
Mainly for brightness auto adjusting.
GAMMA: Gamma setting, press it to adjust the image gamma value.
Gamma values include: LINEAR, sRGB, -1.2, -1.4, -1.6, 1.2, 1.4, 1.6.
ASPECT RATIO: Aspect ratio setting, user can choose 4:3, 16:9 and
DEFAULT.
OUTPUT ADJUST: Output adjust menus, the sub-menu as following:
DVI1, setting as following:
DVI MODE: Can set the protocol as HDMI or DVI, default is DVI output,
HDMI signal output will enable when HDMI option checked.
BIT DEPTH: Can set the image bit depth.
DATE RANGE: DVI1 output range, can set as RGB (graphic mode or
YCbCr (video mode), RGB output scale range is between 0-255, YCbCr
range from 16 to 235.
DE ADJUST: DE adjust, the sub-menu as following:
DE ON/OFF: Can choose to open or close, when choose open, it can be
adjusted to DE, as follows:
H SIZE: Width setting.
V SIZE: Height setting.
H POS: Horizontal phase setting.
V POS: Vertical phase setting.
When the signal source of the screen appear black side, can use this